While having issues with your bathroom fixtures and components occasionally shouldn’t surprise you, you must rectify them to have an efficiently functioning bathroom. If the shut-off valves are fully open and nothing is obstructing the spout or showerhead, consider calling an experienced plumber to help solve the problem professionally.
How to Fix New Moen Shower Valve No WaterĪs mentioned, an obstruction in your spout or showerhead or improper use can cause a new Moen shower not to have water. This post will take you through how to get your Moen shower valve supply water and solve other related issues. However, before discarding your Moen valve or calling a plumber, conduct troubleshooting procedures to see if you can resolve the problem. Your new Moen shower valve probably has no water because water and hot water aren’t getting to the valve because of a spout/showerhead obstruction or improper use.Ī shower valve without water is useless, so you don’t get to enjoy your refreshing showers. Moen offers high-quality, durable shower valves designed to fit the needs and preferences of its users, but what happens when the new Moen shower valve has no water? After the shower has been installed and the wall has been closed, there is little that can be done to remedy this situation yourself.How well you enjoy your shower depends on the water temperature and pressure, and the valve is a vital piece that’s why you need to choose wisely. If none of these help, you may need to call a plumber. Be sure to check the tub spout itself for blockage. Be sure to flush the valve before reinstalling the tub spout.
The act of feeding it causes it to twirl and loosen the blockage. If this is the cause of shower-rise, it is possible to remove the blockage by removing the tub spout, and then feeding a plumber’s snake or a speedometer cable up through the tub drop. Something is impeding the flow of water to the spout and causing it to back up and go out of the shower head. The most common reason is that there is something restricting the water flow to the spout (for example, solder or something lodged in the pipe).Something other than copper or galvanized pipe going to the spout was used.There is more than one 90-degree angle.The length from the valve to the tub spout is outside of the 8" to 18" rule.There can be one of several reasons for this: This causes the water to back up and come out the shower head. Most likely you are experiencing "shower-rise," where the water can’t get out of the spout as fast as it flows through the valve.
0 kommentar(er)
